lennox furnace parts diagramby model number

NOTE - 48' (1219 mm) clearance required on top Under the unit if it will be installed in a location or position that will transmit sound or vibration to the living Refer to figure 2 for installation clearances.ġ - Place a sound-absorbing material, such as Isomode, A minimum clearance of 24 inches (610 mm) between Give adequate clearances for sufficient airflow and servicing. These units operate under a wide range of weather conditions therefore, several factors must be considered when If a support frame is constructed, it must not block drain holes NOTE - Elevation of the unit may be accomplished byĬonstructing a frame using suitable materials. The unit base should be elevated above the Who have jurisdiction before installation.ģ - In heavy snow areas, do not locate unit where drifting These instructions are intended as a general guide and do If you find anyĭamage, immediately contact the last carrier. Ģ - Grommets (for liquid and vapor lines)Ĭheck equipment for shipping damage. įlushing Existing Line Set & Indoor Coil. Indoor TXV kits that must be ordered separately. They are not designed to be used with other refrigerant flowĬontrol devices. HPXB15 outdoor units are designed for use in expansion valve (TXV) systems only. Matching indoor coil and line set as outlined in the LennoxĮngineering Handbook. HPXB15 outdoor units use R410A which is an ozoneįriendly HFC refrigerant.

Lennox furnace parts diagramby model number